7/14/2023 0 Comments Gns3 linux cloud interface![]() ![]() R1 to a cloud that is bridged to eth1, R2 to eth2 and so on. If you would like to know how to enable clouds and bridge them with your network card, please lookup the GNS3 documentation or write a comment, then I maybe if it is wanted I will add a post for that. Prerequisite is that the switches should have names from SW1 to SW4 (for CDP to identify it) and all ports are open and CDP is activated. ![]() We dont know which NIC goes to what Switchport here. So with some cable zippers again it looks very nice I think :).ĭont mind the yellow cables, those are connected to each switch to fa/10, I will use it for management purposes like software updates and config saving via to my mgmt vlan. Here are the interfaces (you can see this also within the INE topology for the R&S rack): ![]() We can figure that out later using CDP :). You actually dont need to know which interface of which nic is name eth4, eth9 and so on. Then take the other two nic cards and do it the same.Īfter that we have to connect those 12 cables to the switches as they represent the router interfaces of R1-R6 and BB2 and BB3. Cables were cheap: length = 2m, price 0,70$ each.įirst what I did was to take 4 of them, then plugged them into the first 4-port NIC and used cable zippers to let it look good. I ordered them in red to get a little color in here. We here need now our straight through patch cables. So now its time to connect our server to the 4 switches in order to make the lab setup complete! ![]()
0 Comments
Leave a Reply. |